European Precision Style

European-system-sectioned-1

Acute Punch

Acute punches are available in angles from 30 to 60 degrees.

Gooseneck Punch

Deep profile punches designed to allow for large return flanges in the workpiece.

Narrow Punch

The straight, narrow punch body allows flanges to wrap around both sides for bending symmetrical profiles.

Sash Punch

A straight, thin punch with a sharp relief offset at the bottom that is perfect for making a door sash.

Standard Punch

General purpose punch that is perfect for bending 90 degree angles.

1V die

1V die – very easy, it is any die with only one opening as a classic choice for bending. Could have the outer shape of a cube or rectangle or T-form for the Promecam system. Groove is centered. If the completely flat surface is also presented it could be used for flattened / hemming applications if has a ground surface. For all big openings more than V=50-60 single V die are usually used everywhere.

2V die

2V die – a bottom tool with 2 openings on one tool. Could be also centered not itself but with the use of special adaptors and to change the opening you just need to rotate the die itself. Moreover could be a change in the v-opening with horizontal or vertical rotation. Or could be standard non-centered which means that to change the opening you should displace the die itself on the press brake table. If the completely flat surface is also presented it could be used for flattened / hemming applications if the surface is ground.

3V/4V die

3V/4V die – the die with 3 or 4 openings on one die on different sides. Groove is centered. If the completely flat surface is also presented it could be used for flattened / hemming applications if the surface is ground. Usually, the variety of openings allows the possibility to use the same tooling for different thicknesses depending on the part.4V die with standard openings is a perfect solution for new presses and companies who just start the bending job. In a lot of new press brake supplies, standard general punch and 4V die are included as a starter set of tooling.pins to rotate the die with the use of lateral chains of the press brake.

multi-v-die

Multi V Dies

Multi V dies offer the ultimate flexibility and efficiency with up to 4 V openings available. Available in angle ranges from to 180 degrees and V openings from 0.236″(6mm) to as wide as 1.968″(50mm).

For modern presses usually, Multi-V dies are not used. Thanks to the holders there is no requirement to clamp the full length in one piece and production of these dies in Europe is very expensive. Anyway as we told you they are requested for old machines or big tonnage and big dimensions machines where changing of different dies could be a very big problem and takes a lot of time.

Multi-V die – die with more than 4 openings, not in the center of the tool. The purpose is the same – the possibility to use for different thicknesses but also request the allowance of the press brake die fixators to displace and adjust the die. These types of dies are quite common for old machines and Asian press brakes and usually are made for the full length of the machine, for example, 3 meters. Because of big weight such dies (or 3V/4V dies as well for big sizes) could have additional side fixation.

Scroll to Top

Download

Fill out the form below to download the relevant brochure.

Submit a Quick Quote